Under the influence of temperature and humidity of the fuel (gasoline, diesel, gas) constantly expands and contracts. In this case the hydrocarbon molecules that make up their base, are attracted to and form groups. Such “molecular clusters” burn engine only partially, since they remain within reach for oxygen.

• Easy to install. You will need only 5 minutes!
• Virtually no carbon-slag swoop. This means that the piston rings are much longer.
• Significantly increased catalyst life.
• Effectiveness is confirmed by numerous studies and tests.
• The term of service of candles increases.
• Much more rarely lit LED «Check engine» (because it just glows due to low-quality fuel, which is badly burned, and after installation FuelFree it burns much better).
• Fully pays for itself in 1-2 months !

You can buy fuel economist FuelFree in the UK online on the official website with a 50% discount.  Customers are invited to apply for the official website. To do this, just to provide a phone number. In the near future you will be contacted specialists who specify the address and the delivery method.

The list of countries where you can buy FuelFree delivery: the United States, Turkey, Thailand, Vietnam, China, Pakistan, India, Japan, Austria, Andorra, Albania, Belarus, Belgium, Bulgaria, Bosnia and Herzegovina, the Vatican, Great Britain, Hungary, Germany, Gibraltar, Greece, Denmark, Ireland, Iceland, Italy, Latvia, Liechtenstein, Lithuania, Luxembourg, Macedonia, Malta, Moldova, Monaco, Netherlands, Norway, Poland, Portugal, Romania, Russia, San Marino, Serbia and Montenegro, Slovakia, Slovenia, Ukraine, Faroe Islands, Finland, France, Croatia, Montenegro, Che Hiya, Switzerland, Sweden, Norway, Estonia

Before beginning work it is very important to choose the right hose as a magnet to reduce fuel consumption involves the installation of a hose only on its delivery. Thus the device itself should be placed as close to the carburetor (injection system) that provide the highest efficiency.

General installation scheme is as follows:

1. Open the hood, find fuel hose.
2. Determine the place where it will be attached magnetic device.
3. Set the machine so that the hose is between its two parts.
4. Secure locking strap by threading it into the hole on the hull, and trim the extra piece.

Depending on the engine type of work process has some features.

ON injection engines

In the presence of vehicle electronic fuel injection system (computer) necessary for 10 minutes to de-energize the magnets installing it, removing the negative contact of the battery. In this case, old data will be cleared and the computer will be able to “adapt” to the new conditions.

Then you need to install the magnets to save fuel for the above scheme, connect the battery to start the vehicle, to an increased load (e.g., turn on the headlights, air conditioning, etc.), Install the crankshaft rotation speed tachometer 2500 rev / min for a few minutes and continue for 2 km . The computer adapt to changes in the fuel system.

On diesel engines

If the vehicle is equipped with a diesel computer system determining the fuel-air mixture, it is necessary to also reset the installation by removing the minus terminal of the battery. Methods of installation is the same as the previous one.

AT carburetor engines

Engines with carburetors are not equipped with computer control. After installation constructed in accordance with the standard scheme, it is necessary to adjust the quality of the mixture alone for normal operation of the engine, because its composition should be less fuel.

On the engine with gas equipment

Adjusting the quality of the fuel-air mixture is performed depending on whether electronic system – also through zero or manually, as in other types of engines. The magnets are mounted on the hose in the same manner, but always after the gas reducer.

Testing Task – fuel consumption comparison at driving device without and after its installation. Note that the first time will be an active removal of carbon-slag deposits, so that the maximum effectiveness of the magnets will appear only after 1500 km run.

To test you need:

• carefully determine the fuel consumption in the interval 300-500 km;
• properly install magnets on the fuel system of the car;
• drive about 1500 km with them;
• determine fuel consumption for the same interval of 300-500 km, observing the same manner of driving and traveling mode (in the same way, when a similar air temperature and the state of the road surface), as well as to the installation of magnets;
• compare the results.

If the installation and testing carried out correctly, the effectiveness of the use of magnets will fully comply with the stated. Are confirmed by numerous positive feedback about this device.

“I WORK IN AN AUTO SHOP. I WANT TO SAY THAT THE ECONOMIZER GOOD BUY. WE ADVISE CLIENTS, SELECTING THE APPROPRIATE SIZE OF THE MAGNETS TO DETERMINE THE VOLUME OF THE CAR ENGINE. THERE IS NO NEED TO PUT A LARGE NUMBER OF DEVICES IN THE CAR – THIS NOTHING WILL. THERE ARE STANDARDS WHICH DEFINE THE SIZE AND NUMBER OF MAGNETS. AND I MET THE DRIVER, WHO MANAGED TO ESTABLISH SIX ECONOMIZERS ON HIS GAZELLE. »
BY EUGEN
« AS A MECHANIC WITH EXPERIENCE OF 10 YEARS, MANY TIMES I HAVE SEEN SIMILAR DEVICES. I MUST SAY THAT SUCH THINGS SKEPTICAL, AND RECOMMEND THEM TO ANYONE I WILL NOT WITHOUT REASON. I WANT TO ADVISE THOSE WHO DOUBT BUY EKONOMITEL FUEL FUELFREE, TO MAKE THEIR OWN HANDS LIKE PRIBORCHIK. TO DO THIS, YOU NEED TO TAKE A COUPLE OF NEODYMIUM MAGNETS AND ATTACH THEM WITH TAPE WRAPPED AROUND THE FUEL TUBE. IF YOU NOTICE A POSITIVE EFFECT, IT IS SAFE TO BUY FROM THE OFFICIAL MANUFACTURER EKONOMITEL. »
SANDRO